Jacuzzi Personal Hygiene System EV77959 - Manual (Page 5)

Installation
(continued)
4
9) Filling the Reservoir
8) Remote Control Installation
a) Identify a location for the Remote Control that is visible and reachable from the
toilet and that does not obstruct the IR signal.
Depending on your wall type, you can install the screws directly or use anchor
mounts (provided) as shown.
b) If you prefer to not drill holes in your wall, you may use double sided foam
tape to adhere bracket to wall. In this case, make sure to choose a tape with an
adhesive that will not damage wall upon removal.
a) Place a plastic sheet (not provided) over the seat. Sit on the Refresh to activate the seat switch. Press one
of the wash functions on the Remote Control. The reservoir will begin to fill. It will take between 5 and 10
seconds for the reservoir to completely fill.
When the reservoir is full the wash wand will extend and begin to spray. Push STOP to cancel the wash
function. Remove the plastic sheet and discard.
b) Your Refresh bidet seat is now ready for use! Refer to the Operation section of this manual for programming
and operation instructions.
Troubleshooting
Issue Possible Causes Solution
1
2
3
4
5
6
7
8
9
1) Clogged filter
2) Twisted hose
3) Household water pressure low
1) Nozzles are dirty
2) Clogged filter
3) Water pressure is too low
1) User not properly seated
2) Seat switch is not contacting toilet
fixture properly
1) Washing time exceeding 5 minutes
2) Power failure
1) Clean filter
2) Straighten hose
3) Increase water pressure to Refresh
1) Clean the nozzles
2) Clean the filters
3) Adjust water pressure
1) Adjust your sitting position
2) Make sure the seat switch is contacting
toilet bowl rim (switch is in seat foot)
1) Repeat cleaning function
2) Check power and/or unplug the cord
to reset
Low water flow or
pressure
Nozzles do not function
properly
Washing feature does not
work or fails to spray
Product shuts OFF
during use
Dryer only operates when activated
by weight of person on seat
Water flow sporadic or
inconsitent
Nozzles fail to react
Seat not heated
Water not heating
Dryer not working
Seat temperature set to OFF
Water temperature set to OFF
Nozzles are dirty
Pulsating / Spa mode activated
Reset heated seat temperature
Reset heated water temperature
Reset to normal washing mode
Sit on Refresh to operate Dryer
Clean nozzles
EX93000 Refresh Installation Manual 10/06