JVC 0610TMH-MW-ST - Manual (Page 59)

59
English
Reference
Refer to the table below to check the condition. If you think that there is a problem, contact the
JVC Service Center where you purchased the television.
There is no power
• Check that the power cord is plugged in properly.
• Check for a blown fuse or circuit breaker, or a power outage.
There is no picture or sound
• The antenna could be disconnected.
• The tuner could be set improperly. See page 53.
•
The TV station may be having difficulties. Check to see if other stations are working.
• Use an HDMI cable with the HDMI logo.
•
If you have a device connected to INPUT-1, INPUT-2 or INPUT-3, you will not be able to
hear any audio from the AUDIO OUT on the back of the TV.
• You cannot output audio using the DIGITAL AUDIO OPTICAL OUT when you have digital
sound from an HDMI device connected to the INPUT-1, INPUT-2 or INPUT-3 connection
on the back of the TV.
• This TV can accept 480i (Composite / S / HDMI / Component), 480p, 720p, 1080i and
1080p signals. Please check your settings.
Remote control is not operating properly or at all
• Check to see that the batteries are still working and properly installed.
• Make sure the remote has a clear sight path to the TV.
• You may be too far from the TV. You must be within 23 feet (7 meters).
The power turns off by itself
• Check that the power cord is plugged in properly.
• Perhaps the Auto Shut Off is set. See page 43.
• Check to see if the Sleep Timer was set. See page 19.
It does not operate correctly
• This television is operated by a microprocessor. It is possible that external noise or
interference is causing the problem. If the television does not function correctly, remove
the electrical plug from the wall outlet and wait a while before inserting it into the wall
outlet again and operating the television.
The color quality is poor
• Tint and Color may be improperly adjusted. See page 26.
• The Video Status mode may be set incorrectly. See page 26.
There are lines across the picture
• There could be interference from another electrical appliance, such as a computer,
another TV or a VCR. Move any such appliances further away from the TV.
The picture is spotted
• There could be interference from a high-wattage appliance, like a hairdryer or vacuum,
operating nearby. Move the antenna away from the appliance or change to a coaxial
cable connection which is less prone to interference.
There are double pictures (ghosts)
• A building or passing airplane may reflect the original signal and produce a second,
slightly delayed one. Adjust your antenna position.
Troubleshooting
EN_LT32P510.indb 59 EN_LT32P510.indb 59 10.6.1 6:01:51 PM 10.6.1 6:01:51 PM