JL Audio Stealthbox SB-D-TRKEXT/10W1 - Manual

➔
➔
Stealthbox ®
I N S T A L L A T I O N G U I D E
S B - D - T R K E X T / 1 0 W 1 , J L AU D I O, I n c 2 0 0 4 S h e e t S K U # 0 1 1 1 0 5 R ev i s i o n 6 / 2 8 / 2 0 0 4 Pa g e 1
for the
SB-D-TRKEXT/10W1
(Dodge Ram
‘94-’01 1500 Club Cab,
‘98-’01 1500 Quad Cab,
‘94-’02 2500 Club Cab,
‘98-’02 2500 Quad Cab,
‘95-’02 3500 Club Cab,
‘98-’02 3500 Quad Cab)
This Stealthbox is a product which
requires professional installation skills and
tools.
Please read this installation guide thor-
oughly before beginning the project. It
will guide you step by step through the
installation. Several of the steps in this
process may require two people to
accomplish.
It is absolutely vital that the enclosure
be properly mounted to the vehicle
according to these instructions. Failure
to mount the enclosure properly pres-
ents two problems: 1) The sub-bass
performance will suffer due to the
movement of the enclosure caused by
the force exerted by the woofer(s) and
2) A loose enclosure presents a serious
safety hazard in the event of a collision
or sudden deceleration.
Please enjoy your JL Audio Stealthbox
responsibly.
STEP 1: Slide the front seats all the way for-
ward and fold-up the rear bench seat.
STEP 2: Under the rear bench seat, there are
a pair of metal brackets which hold the tire
changing tools. Bend these up and back so
they are out of the way of then enclosure.
STEP 3: Place one of the two supplied wax
squares to this location(remove paper, sticky
side down).
The outside edge of the wax square needs to
be flush with the jack storage compartment.
The rear edge needs to be 5-1/2” from the
ledge at the back of the cab floor.
STEP 4: Place the other supplied wax square
to this location. (remove paper, sticky side
down).
The rear edge needs to be 5-1/2” from the
back of the cab.The inside of the wax square
needs to be 5-1/2” from the outside edge of
the carpet.
START
HERE
Continued on Next Page ➔
w w w . j l a u d i o . c o m
➔
➔