JVC SR- DVM600U - Manual (Page 53)

Masterpage:Right+
EN
53
Filename [DVM600US_11Editing.fm]
EDITING
Page 53 Monday, 25 September 2006 13:54
You can dub selected audio from a DVD or Audio CD disc to a
digital audio device.
However, it is not possible to dub copy-protected discs.
Example: Dubbing to an MD
1
Connect the unit and a digital audio device using either an
optional optical cable or an optional coaxial cable.
2
Place a disc on the unit and load an MD on the connected
digital audio device.
3
Select the audio to be dubbed.
4
Start playback slightly before the actual point from where you
wish to start dubbing.
5
Press W to pause playback.
6
Select the input mode on the connected digital audio device.
7
Press I to start playback on the unit.
8
Start recording on the digital audio device.
9
Stop recording on the digital audio device. Then press o to stop
playback on the unit.
NOTE:
There may be a discrepancy of several seconds between where
you intend editing to start, and where it actually starts.
Digital Audio Dubbing
● Turn on the TV and select the AV mode.
● Slide the TV/DVD switch to DVD.
Rear of unit
Note for connection:
Remove the protection cap from the optical cable.
Digital audio device
(MD deck, etc.)
Coaxial cable
(not supplied)
Player
Recorder
To [DIGITAL AUDIO
OUTPUT (COAXIAL)]
To [DIGITAL AUDIO
OUTPUT (OPTICAL)]
Optical cable
(not supplied)
DVM600US_00.book Page 53 Monday, September 25, 2006 1:54 PM