Jwin JT-P570 - Manual (Page 7)

12/30/20039:53 AM Page7
number.
MUSIC ON-HOLD BUTTON
To put your party on hold position, press the H
OLD button. A pre-programmed music
selection will play automatically for the party on hold.
RELEASING HOLD
Lift the receiver or press the
SPEAKER button and speak to the holding party.
PAUSE BUTTON
In some cases, such as PABX (Private Automatic Branch Exchange) or for some long
distance services, a pause should be part of the dialing sequence. The unit provides a
stackable pause function (3.6 sec/pause).
MUTE BUTTON
To temporarily prevent the party on the line from hearing a private conversation you may
be holding with someone else, press the mute button and deep it depressed. Release
the button to resume your phone conversation.
P-T BUTTON
During pulse dialing, the P-T key provides automatic switching from pulse to tone dialing
mode. Tone information can be stored in memory for autodial and redial functions.
TRANSFERRING CALLS
When in an office equipped with PABX, your unit makes it easy to transfer calls.
• Ask calling party to wait.
• Press and release the
FLASH button.
• Dial the number of the party you wish to transfer to.
• When the party answers, announce the call and hang up.
If you receive a busy signal or no answer:
• Press
the
FLASH
button to re-connect to your party.
RECEIVER VOLUME CONTROL
Slide the control from Min to Max to select the volume that you wish.
HANDSFREE SPEAKER VOLUME CONTROL
Slide the control from Min to Max to select the volume that you wish.
RINGER VOLUME CONTROL
Move the volume switch of handset:
“HI” = High volume
“LO” = Low volume
OFF – There will be no sound to indicate an incoming call, but there will be
a flashing light to signal you.