Jaton Communicator V.90 - Manual (Page 49)

49
Command Description
Wn Connect Message (Default=0) This command is provided for
compatibility. The S95 Register should be used with new
applications.
W0 Reports only the DTE speed.
W1 Reports the DCE speed, protocol, and DTE speed.
W2 Reports only the DCE speed.
Xn Extended Result Codes end Call Progress Options (Default=4)
Ext. Result Code Dial Tone Detect Busy Tone Detect
X0 Disable Disable Disable
X1 Enable Disable Disable
X2 Enable Enable Disable
X3 Enable Disable Enable
X4 Enable Enable Enable
Extended Result Codes:
Disabled: Displays only the basic result codes OK,
CONNECT,
RING, NO CARRIER, ERROR.
Enabled: Displays basic result codes, along with the connect
message and the connect data rate.
Dial Tone Detect:
Disabled: The modem waits the period of time specified by S6
and then dials a call regardless of whether it
detects
a dial tone. (Blind Dialing)
Enabled: The modem dials only upon detection of dial tone,
and disconnects the modem if the dial tone is not
detected within the period of time specified by S6.
Busy Tone Detect:
Disabled: The modem ignores any busy tones it receives.
Enabled: The modem monitors for busy tones.
Yn Long Space Disconnect (Default=0)
Y0 Disable Long Space Disconnect.
Y1 Enable Long Space Disconnect generation and response.
Zn Soft Reset and Reload Active Profile
Z0 Soft reset and reload active profile from stored profile 0.