Important – John Deere ET-3403-J User Manual
Page 9
10-Inch Compound Miter Saw Operator's Manual
9
REPLACEMENT PARTS
When servicing use only identical replacement parts.
Repairs should be conducted only by a JOHN DEERE authorized dealer.
SAVE THESE INSTRUCTIONS
AND MAKE THEM AVAILABLE TO OTHER USERS OF THIS TOOL!!
SPECIFIC SAFETY RULES FOR USE OF THIS POWER TOOL
WARNING: THE FOLLOWING SPECIFIC OPERATING INSTRUCTIONS MUST BE OBSERVED WHEN
USING THIS POWER TOOL IN ORDER TO AVOID INJURY.
DON'Ts:
NEVER VIOLATE THE FOLLOWING RULES TO ASSURE SAFE USE OF THIS TOOL:
1.
Never operate the POWER TOOL unless you fully understand the operating instructions contained in this
Manual.
2.
Never leave the POWER TOOL unattended without first unplugging the power cord.
3.
Never operate the POWER TOOL when you are tired, after you have taken any medications, or have
consumed any alcoholic beverages.
4.
Never use the POWER TOOL for applications not specified in the instruction manual.
5.
Never operate the tool while wearing loose clothing, a necktie or jewelry, or while your hair is uncovered, to
protect against getting caught in the moving machinery.
6.
Never reach around the saw blade.
7.
Never touch any moving parts, including the blade, while the saw is in use.
8.
Never remove any safety devices or blade guards; use of the tool without them would be hazardous.
9.
Never lock the safety cover; always confirm that it slides smoothly before using the tool.
10. Never damage the power cord of the tool.
11. Never attempt to move a plugged-in POWER TOOL while your finger is on the starting switch.
12. Never use the POWER TOOL if the starting switch does not turn on and off properly.
13. Never use the POWER TOOL if the plastic housing or the handle is cracked or deformed.
14. Never use the POWER TOOL near flammable liquids or gases because sparking can cause an explosion.
15. Never clean plastic components with solvents because the plastic may dissolve.
16. Never operate the saw unless all the blade guards are in place.
17. Never raise the saw blade from the workpiece until it has first come to a complete stop.
18. Never cut ferrous metals or masonry.
19. Never place your limbs inside of the line next to warning sign " " while the tool is being operated. This may
cause hazardous conditions.
20. Never use abrasive type blades on this saw.
21. Never expose to rain or use in damp locations.
22. When you cut the workpiece, avoid any cut off thinner than the clearance between the cutting edge and the saw
blade. Otherwise, the cut off material can enter the clearance between the cutting edge and the saw blade and
scatter around you, resulting in injury.
IMPORTANT