JVC GET0721-001A User Manual

Page 18

Advertising
background image

18

ENGLISH

Menu item

Selectable setting, [Initial: Underlined]

AUDIO

FADER *

3,

*

4

R06 — F06 [ 00 ] : Adjusts the front and rear speaker output balance.

BALANCE *

4

L06 — R06 [ 00 ] : Adjusts the left and right speaker output balance.

LOUD

ON : Boost low and high frequencies to produce a well-balanced sound at a low volume
level. /

OFF : Cancels.

VOL ADJUST

–05 — +05 [ 00 ] : Presets the volume adjustment level of each source (except
“FM”), compared to the FM volume level. The volume level will automatically increase or
decrease when you change the source. Before adjustment, select the source you want to
adjust. (“VOL ADJ FIX” appears on the display if “FM” is selected as the source.)

SUB.W

ON : Turns on the subwoofer output. / OFF : Cancels.

SUB.W LPF

LOW 55Hz / LOW 85Hz / LOW 120Hz : Frequencies lower than
55 Hz/85 Hz/120 Hz are sent to the subwoofer.

SUB.W LEVEL

00 — 08 [ 04 ] : Adjusts the subwoofer output level.

HPF

ON : Activates the High Pass Filter. Low frequency signals are cut off from the front/rear
speakers. /

OFF : Deactivates (all signals are sent to the front/rear speakers).

BEEP

ON / OFF : Activates or deactivates the keypress tone.

TEL MUTING *

5

ON : Mutes the sounds while using the cellular phone (not connected through
KS-BTA100). /

OFF : Cancels.

AMP GAIN *

6

LOW POWER : VOLUME 00 – VOLUME 30 (Selects if the maximum power
of each speaker is less than 50 W to prevent damaging the speakers.) /
HIGH POWER : VOLUME 00 – VOLUME 50

TUNER

SSM *

7

For settings, see page 8.

AREA

US : When using in North/Central/South America. AM/FM intervals are set to
10 kHz/200 kHz. /

EU : When using in any other areas. AM/FM intervals are set to

9 kHz/50 kHz. /

SA : When using in South American countries where FM interval is

50 kHz. AM interval is set to 10 kHz.

MONO *

7

For settings, see page 8.

BLEND HOLD *

7

For settings, see page 8.

IF BAND

AUTO : Increases the tuner selectivity to reduce interference noises between adjacent
stations. (Stereo effect may be lost.) /

WIDE : Subject to interference noises from

adjacent stations, but sound quality will not be degraded and the stereo effect will
remain.

TAG ALL CLEAR

For settings, see page 10.

*

3

If you are using a two-speaker system, set the fader level to “00.”

*

4

This adjustment will not affect the subwoofer output.

*

5

This setting does not work if <BT ADAPTER> is selected for <R-AUX> of the <SRC SELECT>.

*

6

The volume level automatically changes to “VOLUME 30” if you change to <LOW POWER> with the volume
level set higher than “VOLUME 30.”

*

7

Displayed only when the source is “FM” or “AM.”

EN02-23_KD-AHD79[J]3.indd 18

EN02-23_KD-AHD79[J]3.indd 18

11/22/10 3:11:53 PM

11/22/10 3:11:53 PM

Advertising