JVC CB100 - Manual (Page 51)

Chapter 3—Operation
HJT Model 100 User's Guide 3-23
3.13.2. Communications Protocol
Select S ETTINGS using the menu bar, then select C OMMUNICATIONS .
Set the following communications parameters and modes.
Table 3.0-9 Communication Protocol
Modes Parameters
Baud Rate 9600
Data Bits 8
Parity None
Parity Check No
Connector Com1—this is PC configuration dependent
Stop Bits 1
Flow Control X ON /X OFF
Carrier Detect No
Select F ILE from the menu bar and select N EW . Under F ILE N AME enter VT-100.TRM.
This will allow the user to select the file VT-100.TRM with the parameters listed in
Table 3.0-9 saved for future use.
Table 3.0-10 VT-100 Terminal and Remote Command Equivalents
Action
Keyboard
Input
Standard
Remote
Keys
Technician
Remote
Keys Decimal Hex
Power O FF (All) C TRL + F 6 6
Power O N (All) C TRL + U 21 15
Power O N /O FF C TRL -P Power Power 16 10
Power O N /O FF
(Electronics only)
C TRL + E 5 5
Power O N /O FF Lamp C TRL + L 12 0C
Left Arrow Left Arrow Left Arrow Left Arrow 27 91 68
∇ ∇ ∇ ∇
1B 5B 44
∇ ∇ ∇ ∇
Right Arrow Right Arrow Right Arrow Right Arrow 27 91 67
∇ ∇ ∇ ∇
1B 5B 43
∇ ∇ ∇ ∇
Up Arrow Up Arrow Up Arrow Up Arrow 27 91 65
∇ ∇ ∇ ∇
1B 5B 41
∇ ∇ ∇ ∇
Down Arrow Down Arrow Down Arrow Down Arrow 27 91 66
∇ ∇ ∇ ∇
1B 5B 42
∇ ∇ ∇ ∇
Back out of menu E SC E SCAPE E SCAPE 27 1B
Blanking B Blank 66 42
Bow, H & V U Bow 85 55
Brightness I Bright 73 49
Center, H & V (RGB) P Center 80 50
Change channel Number
+ E NTER
Channel #
+ E NTER
Channel #
+ E NTER
48-57 30-39 + 0D
Color Y 89 59
Contrast (RGB) C Cont 67 43
Edge, H & V (RGB) E EdgeLin 69 45
Enter E NTER E NTER E NTER 13 0D
Escape Esc E SCAPE E SCAPE 27 1B