JVC XM-228BK - Manual (Page 15)

11
English
3 Select desired track numbers to be programmed.
Main unit:
1 Turn the jog dial to the right or left to select the desired track number to be
programmed. (Turning it to the right increases the track number and vice versa.)
The selected track number will blink.
2 Press SET.
The track number stays lit and the program number increases by 1. Also, the
programmed track is indicated on the music calender.
Then, the total playing time is displayed instead of the program number.
Example)
3 Repeat steps 1 and 2 to select the other tracks for the program.
Remote control unit:
1 Select the desired track number with the numeric keys.
The selected track number is programmed and the program number is displayed.
Then, the total playing time is displayed instead of the program number.
To select a track, see “Selecting a track with the numeric keys” on page 9.
2 Repeat step 1 to select the other tracks for the program.
4 Press 6 on the main unit or 3 on the remote control
unit.
Program playback starts in the programmed order.
• Program playback stops after having played all programmed tracks.
• To stop playing, press
7 on the main unit or the remote control unit.
• To skip the programmed track, turn the jog dial on the main unit to the right or left
or press
4 or ¢ on the remote control unit.
To check the programmed tracks and their order (In Stop
mode):
Press
4 or ¢ on the remote control unit in Stop mode. The programmed tracks will be
successively displayed in the programmed order. (The track title will be displayed before
the track number, if it is written.)
If you make a mistake in programming (In Stop mode):
Press
7 STOP/CANCEL on the main unit or CANCEL on the remote control unit in Stop
mode to clear the last track. Each press of the button clears the last track in the program.
Press the button repeatedly until the track you programmed by mistake is cleared and then
re-program tracks from that point.
To exit Program Play mode (In Stop mode):
Main unit:
Press PLAY MODE in Stop mode to select any mode other than Program Play mode.
Remote control unit:
Press PROGRAM in Stop mode to light off the PROGRAM indicator.
The program contents remain in memory even after the unit has exited Program Play mode.
Note: The program contents are cleared from memory when the power cord is unplugged
or in case of power failure.
or
or
CANCEL
or
PROGRAM
Total playing time
The last programmed track
Number of programmed tracks
The last programmed track
XM-228BK(E)-Eng. p.1-16 98.9.24, 9:57 AM 11