John Deere ET-3406-J - Manual (Page 16)

16 Cordless Circular Saw Operator's Manual
3. Charging: When the battery is connected to the battery charger, charging will commence
and the pilot lamp will light in red. (See Table 2):
NOTE: If the pilot lamp flickers in red, pull out the plug from the receptacle and check if the
battery is properly mounted.
When the battery is fully charged, the pilot lamp will blink in red slowly. (At 1-second intervals)
(See Table 2)
a. Pilot lamp indication: The indications of the pilot lamp will be as shown in Table 2,
according to the condition of the charger or the rechargeable battery.
b. Regarding the temperature of the rechargeable battery. The temperatures for
rechargeable batteries are as shown in the table below, and batteries that have
become hot should be cooled for a while before being recharged.
c. Regarding recharging time (At 68°F / 20°C) In approx. 60 minutes.
Assembly
CHARGING METHOD: (CONTINUED)
Table 2: Indications of the pilot lamp
Table 3: Recharging of batteries that have become hot.
NOTE: The charging time may vary according to temperature and power source
voltage.
Lights for 0.5 seconds. Does not light for
0.5 seconds. (off for 0.5 seconds)
Lights continuously
Lights for 0.5 seconds. Does not light for
0.5 seconds. (off for 0.5 seconds)
Lights for 0.1 seconds. Does not light for
0.1 seconds. (off for 0.1 seconds)
Lights continuously
Before
charging
While
charging
Charging
complete
Charging
impossible
Charging
impossible
Malfunction in the
battery or the
charger
The battery
temperature is
high, making
recharging
impossible.
Blinks
(RED)
Lights
(RED)
Blinks
(RED)
Flickers
(RED)
Lights
(GREEN)
Temperatures at which the battery can be recharged
23°F—140°F
(–5°C—60°C)
Rechargeable batteries
EB18B