John Deere ET-3406-J - Manual (Page 22)

22 Cordless Circular Saw Operator's Manual
Operation
OPERATION:
MOUNTING AND DISMOUNTING THE SAW BLADE
CAUTION: TO AVOID SERIOUS ACCIDENT, ENSURE THE
SWITCH IS IN THE OFF POSITION, AND PULL OUT
THE BATTERY.
1. Dismounting the saw blade:
a.
Set the cutting volume at maximum, and place the
Circular Saw as shown in Fig. 17.
b. Depress the lock lever, lock the spindle, and remove the
hexagonal-head bolt and washer (B1) with the box
wrench.
c. While holding the safety cover lever to keep the safety
cover fully retracted into the saw cover, remove the saw
blade. (Fig. 18)
2. Mounting the Saw Blade (Fig. 19):
WARNING: IF THE BOLT IS WORKED USING OTHER
TOOLS THAN THE PROVIDED BOX WRENCH,
EXCESSIVE TIGHTENING AND INSUFFICIENT
TIGHTENING MAY TAKE PLACE, RESULTING IN
INJURY.
Take steps which are the reverse of detaching
procedures.
NOTE: Thoroughly remove any sawdust which has accumulated
on the spindle, bolt and washers.
To assure proper rotation direction of the saw blade, the
arrow direction on the saw blade must coincide with the
arrow direction on the saw cover.
Using the fingers, tighten the hexagonal-head bolt
retaining the saw blade as much as possible. Then
depress the lock lever, lock the spindle, and thoroughly
tighten the hexagonal-head bolt.
CAUTION: AFTER MOUNTING THE SAW BLADE,
RECONFIRM THAT THE LOCK LEVER IS FIRMLY
SECURED IN THE PRESCRIBED POSITION.
(Fig. 17)
(Fig. 18)
(Fig. 19)
(Fig. 20)