Jet Tools M-708620 - Manual (Page 6)

6
Contents of Shipping Carton
1. Air Filtration Unit
1. Remote Control
2. AAA Batteries
4. Eye Bolts & Nuts
4. Mounting Brackets
8. Hex Cap Screws
8. Lock Washers
4. Foam Pads
1. Velcro Pad
1. Manual and Warranty Card
Tools Required for Assembly
•
No. 2 Cross Point Screwdriver
•
10mm Wrench
•
The air filtration unit does not require much
assembly.
You should take into
consideration how and where you will place
this unit.
•
It can be mounted horizontally and vertically.
The unit can also be hung from the ceiling.
•
This unit will work best if it is located away
from corners, and heating/cooling vents.
•
If using on sawhorses the air filtration unit
should be clamped in place.
•
This unit is specifically designed to circulate
and
filter non-metallic dust, which is
generated throughout the work area.
Assembly
CAUTION!
Mounts must be anchored to building
structure, which will support a minimum of
at least 100 pounds. Never mount to
surfaces such as dry wall or false ceiling
grids, etc.
1. Remove all packing from inside of the
unit by removing the outer filter and
inner filters.
2. The air filtration unit can be hung from the
ceiling.
Remove four screws from the
cabinet top (A, Fig. 1).
3. Hang the unit using four eyebolts (B, Fig. 1),
and four hex nuts (C, Fig. 1) provided.