Jet Tools M-708620 - Manual (Page 7)

7
4. The lock nut needs to be threaded almost all
the way up the eyebolt. Screw the eye bolt
into the hole and tighten lock nut against the
cabinet top.
You will need to hold the
eyebolt so it does not spin while tightening
the lock nut.
5. Repeat steps for remaining three eyebolts.
Note: Make sure chain and ceiling hooks are
properly rated for hanging this unit. Hang unit
with a seven-foot clearance from the floor.
CAUTION!
Mounts must be anchored to building
structure, which will support a minimum of
at least 100 pounds. Never mount to
surfaces such as dry wall or false ceiling
grids, etc.
1. Four brackets can also be used for mounting
to the ceiling, or wall.
2. Place one end of bracket underneath the lip
of the cabinet.
3. Attach the bracket (A, Fig. 2) with two hex
cap screws (B, Fig. 2) and two lock washers
(C, Fig. 2).
4. Repeat steps for remaining three brackets.
5. Peel off the paper backing, on the foam
pads, and stick to the bottom side of the
machine’s four corners.
Controls and Features
Remote Control:
Time button (A, Fig. 3) controls the three
different settings.
2H will light up on the back of the unit with one
press of the time button.
The air filtration
system will operate for 2 hours then shut off.
4H will light up on the back of the unit by
pressing the time button twice. The air filtration
system will operate for 4 hours then shut off.
8H will light up on the back of the unit by
pressing the time button three times.
The air
filtration system will operate for 8 hours then
shut off.