JVC HR-J480EU EN - Manual (Page 10)

Filename [HRJ480EU1.fm]
Masterpage:Left
10
EN INITIAL SETTINGS (cont.)
Preset Download
Auto Channel Set by Downloading
from TV/Auto Clock Set/Auto Guide
Program Number Set
NOTES:
● For details, refer to the instruction manual of your TV.
● In the area where no TV station transmits a PDC (Programme
Delivery Control) signal, the recorder can perform neither
Auto Clock Set nor Auto Guide Program Number Set.
● If there is a power cut, or if you press 1
or MENU while
downloading or set up is in progress, it will be interrupted; be
sure to turn off the recorder power once and try again from the
beginning.
● Auto Clock Set may not function properly depending on the
reception condition.
● On this recorder, the characters available for station names
(ID) are A–Z, 0–9, –,
f
, + and
I
(space). Some names of
downloaded stations may differ from those of your TV
(
੬
pg. 42).
If you have connected the recorder to your TV via the AV
connection (
੬
pg. 7), the recorder will automatically perform
Preset Download instead of the Auto Set Up in step 4 on page 9.
After downloading, the recorder sets the clock and Guide
Program numbers automatically.
A
Perform Preset Download.
Press OK. The AUTO SET/T-V LINK display appears on
the front display panel and/or on the TV screen.
On the front display panel
Press
rt to select “CH – –” and press OK or e .
B
Set the video channel.
Set the video channel to off manually. (
੬
pg. 46)
ATTENTION
You can use this function only with a TV offering T-V Link,
etc.* Be sure to use a fully-wired 21-pin SCART cable.
* Compatible with TVs offering T-V Link, EasyLink, Megalogic,
SMARTLINK, Q-Link, DATA LOGIC or NexTView Link via
fully-wired 21-pin SCART cable. The degree of compatibility
and available functions may differ by system.
Perform steps 1 to 3 of “Auto Set Up” on page 8 before
continuing.
On the on-screen display
Press
rt to move the
highlight bar (pointer) to
“T-V LINK” and press OK or
e .
Preset positions on the front display panel increase from
“CH1”; do NOT press any button on the recorder or remote
control until the front display panel shows clock time,
“(CH) 1” or “– –:– –” as illustrated on page 11.
● If you are using the on-screen
display, the T-V LINK screen
will appear. Then the GUIDE
PROG SET screen will appear
during Guide Program
Number Set. When Preset
Download is completed,
“COMPLETED” appears for
about 5 seconds, then the
normal screen appears.
● If you press any button on the
recorder or remote control
while downloading is in
progress, it will be interrupted.
HRJ480EU1.fm Page 10 Friday, January 12, 2001 10:50 AM