JVC HR-J259EE - Manual (Page 25)

EN
25
ENTER CHANNEL POSITION
6
Press TV PROG +/–.
SET TAPE SPEED
(HR-J459EE ONLY)
7
Press SP/LP ( ) to set the tape speed.
SET VPS MODE
8
Press VPS (NUMBER key "7") to select "ON" or "OFF".
If "VPS/PDC OFF" is displayed on the screen or "VPS/
PDC" is lit on the display panel, VPS is set to OFF.
If "VPS/PDC ON" is displayed on the screen or "VPS/PDC"
is not lit on the display panel, VPS is set to ON.
੬
"VPS Recording" in the right column.
● PDC (Programme Delivery Control) recording is not
possible with this recorder.
RETURN TO NORMAL
SCREEN
9
After confirming all information is correct, press PROG.
or OK. "PROGRAM COMPLETED" appears on the
screen for about 5 seconds, then normal screen
appears.
● Repeat steps 1 – 9 for each additional programme.
ENGAGE RECORDER’S
TIMER MODE
10
Press TIMER. The recorder turns off automatically and
‰
appears on the display panel.
● To disengage the timer, press TIMER again.
To Timer-Record Weekly Or Daily Serials . . .
. . . anytime during steps 2 through 9, press WEEKLY (NUMBER
key “9”) for weekly serials or DAILY (NUMBER key “8”) for
daily serials (Monday – Friday). Either "WEEKLY" or "DAILY"
appears on the screen. Pressing the button again makes the
corresponding indication disappear.
SP
– P1 –
START STOP
21:00 = 22:00
SP VPS/PDC OFF
DATE TV PROG
25.12 1
RTR
[+/–] =
[PROG] : EXIT
Satellite Tuner Users
To timer-record a satellite broadcast using Express Timer
Programming:
1
Perform steps 1 – 10. Enter "F-1" for the channel
position in step 6.
2 Set the satellite tuner to the appropriate channel before
the selected programme begins.
3 Leave the satellite tuner's power on.
NOTE:
You can programme this recorder to timer-record as many as 8
programmes. If you try to programme the recorder to record a
ninth, "PROGRAM FULL" appears on screen and "FULL" appears
on the front display panel. To record the extra programme, you
must first cancel any unnecessary programmes (
੬
pg. 26).
Now available from some TV stations, VPS (Video
Programme System) is a service designed to assure safe,
accurate timer recording. With this system, special code
signals are transmitted together with the audio/video
signals. These code signals control your video recorder and
have precedence over the advertised times you may have
preset into the timer. This means that your recorder will
start and stop recording when the preset TV programmes
actually start and end — even if the broadcast time of a
preset TV programme is changed.
NOTE:
When you use Express Timer Programming, set the start
time (VPS time) exactly as advertised in the TV listing. A
different time than advertised will result in no recording.
VPS Recording