JVC HR-J259EE - Manual (Page 33)

EN
33
VIEW CHANNEL LIST
SCREEN
4
After "SCAN COMPLETED"
is displayed on the screen
for about 5 seconds, the
Channel List screen
looking like the one to the
right appears. The stations
your recorder located
appear on the Channel List
screen — channel
positions (PR) and
channels (CH).
The blueback screen and the program currently being
broadcast by the blinking station appear alternately for
8 seconds each.
To view the next page, use the PUSH JOG
%fi button
on the remote control.
RETURN TO NORMAL
SCREEN
5
Press MENU.
● Using the Channel List screen, you can skip or add
channel positions, enter station names and perform
other operations. Refer to pages 34 – 37 for the
procedures.
PR CH ID PR CH ID
01 25 – – – – 07 C33 – – – –
02 C08 – – – – 08 C26 – – – –
03 10 – – – – 09 55 – – – –
04 C65 – – – – 10 C24 – – – –
05 C31 – – – – 11 C23 – – – –
06 C32 – – – – 12 C25 – – – –
[ 5∞]
= : EDIT
= [X] : DELETE
[MENU] : EXIT
NOTES:
● Fine tuning is performed automatically during Auto Channel
Set. If you want to perform it manually, refer to page 35.
● If you perform Auto Channel Set when the aerial cable is not
connected properly, "SCAN COMPLETED -NO SIGNAL-"
appears on the screen in step 4. When this happens, make
sure of the aerial connection and press OK; Auto Channel Set
will take place again.
C: Cable
IMPORTANT
● If no sound accompanies the picture on some channels
that have been stored by Auto Channel Set, the TV
system setting for those channels may be incorrect. Select
the appropriate TV system for those channels.
੬
"TV
System Selection – When you see the picture but hear no
audio" on page 37.
● Since your video recorder memorizes all detected
stations even if the reception condition is poor, some of
those stored stations may produce a noisy picture. To
delete those stations,
੬
"Delete A Channel" on page 35.
1 2 3
4 5 6
7 8 9
0
2
4
1
3
MENU
OK
PUSH JOG