Jotul GF 100 DV II - Manual (Page 30)

30
GF 100 DV II Nordic QT
GF 200 DV II Lillehammer
Optional
Antique Brick Panel Kit
155815
Installation
1. Remove the Top Plate. Simply lift it up off of the
stove body. It is not fastened.
2. GF 100 DV II ONLY: Remove the Front Plate by lifting
straight up to disengage it from the sides.
3. Remove the Glass Frame. Disengage the two trunk
latches located at the top of the firebox and lift the
glass frame up and out of the firebox.
4. If installed, remove the Logset.
These parts are not fastened. Simply lift them out
of the firebox. You do not have to remove the
embers.
5. Install the Lower Panel.
Position it up against the back wall, resting on the
Burner Skirt. Fig. 43.
6. Install one of the Side Panels, pushing it up against
the firebox wall. Fig. 44
7. Position the Upper Panel. You should seat the
Upper Panel down and forward so that no gaps are
evident at the panel joints, as in Fig. 44.
8. Install the other Side Panel while holding the Upper
Panel in position.
Adjust the panels so that the mortar joints align with
those adjacent.
9. Install the Logset. Refer to pg. 20.
BE CERTAIN THAT NO EMBERS ARE BLOCKING THE PILOT
ASSEMBLY OPENING.
10. Replace the Glass Frame.
Slide the frame down the slot in the front of the firebox.
Be sure to push the frame into the slot in the bottom to
ensure it is fully seated. The gasket at the top of the
frame should be flush with the top of the firebox.
Re-engage the trunk latches with the top lip of the glass
frame.
11. Replace the Top Plate.
Tools Required: Safety glasses and gloves
Figure 44 . Install the Upper and Side Panels.
Lower Panel
221116
Right Panel
221115
Upper Panel
221117
Left Panel
221114
Figure 43. Install the Lower Rear Panel
Burner Skirt
CAUTION!
THE BRICK PANELS ARE EXTREMELY
FRAGILE. HANDLE WITH CARE. WEAR
SAFETY GLOVES TO PROTECT HANDS.
Figure 42. Brick Panel Kit Contents.