GE 98073 GE Ultracam - Manual (Page 13)

13
7. AI
a) This allows you to take up to 60 second video clips.
b) Press the mode button until AI appears in the LCD screen;
then press and hold the shutter release button to begin the
video.
c) When finished video recording, release the shutter release
button. Note: The video taken will be an AVI file.
8. St
a) This sets the camera timer to automatically take the picture
within ten seconds from when the shutter release button was
pressed.
b) Mount the camera on the tripod
c) Point the camera at the desired subject.
d) Press the mode button until St appears in the LCD screen; then
press and release the shutter release button to activate the self-
timer.
e) The red light on the front of the camera will begin to blink.
After ten seconds the camera will take the picture.
9. dP
a) This will delete the last picture taken.
b) Press the mode button until dP appears in the LCD screen.
c) Press the shutter release button.
d) dP will begin to flash. Press the shutter release button again.
10. dA
a) This will delete the last audio that was recorded.
b) Press the mode button until dA appears in the LCD screen.
c) Press the shutter release button.
d) dA will begin to flash. Press the shutter release button again.