John Deere ET-3409-J - Manual (Page 13)

Table Saw Operator's Manual 13
Assembly
ASSEMBLY PROCEDURES:
1. Assembly of Handle Bar (Fig. 5):
The handle bar allow faster turning of the wheel. When properly
assembled it will rotate freely but with only a small amount of play.
a.
Tighten the screw of the handle bar until it hits against the wheel.
b. Securely tighten the handle bar nut with a wrench.
2. Installing of Rip Fence (Fig. 6):
CAUTION: THE RIP FENCE MUST BE ALIGNED PARALLEL
TO THE SAW BLADE TO MINIMIZE THE
KICKBACK.
The rip fence can be conveniently used to cut a workpiece into different
pieces of precise width or into parallel pieces. It can be mounted on
either the right or left side of the table.
a.
Tighten the screw of the grip.
b. Catch the hook of the support in the bottom part of the rear rail.
c. Lower the rip fence in the arrow direction and fit the part of the width
body and support to the groove of the front and rear rail.
d. Confirm that the rip fence is moved right and left and it moves
smoothly.
3. Assembly of Miter Gauge (Fig. 7):
The miter gauge is convenient for cutting long or angular pieces which
are difficult to work on with the rip fence. It can be mounted on either the
right or left side of the table. Align the sheet bar of miter gage with the
miter gauge groove and slide it in the direction indicated by the arrow
through the front of the table.
(Fig. 5)
WARNING: TO AVOID AN ACCIDENT OR PERSONAL INJURY, ALWAYS CONFIRM THAT THE SWITCH
IS TURNED OFF AND THE POWER PLUG HAS BEEN DISCONNECTED FROM THE
RECEPTACLE BEFORE ASSEMBLY OF THIS TOOL.
(Fig. 6)
(Fig. 7)