John Deere ET-3409-J - Manual (Page 5)

Table Saw Operator's Manual 5
ALWAYS KEEP GUARDS IN PLACE and in working order.
ALWAYS KEEP WORK AREA CLEAN
Avoid injuries by not cluttering the work areas and work benches.
NEVER USE TOOL IN HAZARDOUS
ENVIRONMENTS
Never use the power tool in damp or wet places and never expose it to rain.
Always keep the work area well lighted.
NEVER PERMIT CHILDREN OR OTHERS TO LOITER NEAR THE WORK
AREA
Keep all people (especially children) away from the work area. Always unplug
unattended tools and keep the work place tamper-proof by installing locks on the
doors and on the master switches. Always remove the safety key from the switch
and store it in a secure place, when the tool is not in use.
ALWAYS WEAR PROPER APPAREL WHEN WORKING WITH THE TOOL
Never wear loose clothing, gloves, neckties, rings, bracelets or other jewelry
which may get caught in the moving parts. Always wear nonslip footwear,
preferably with steel toes. Wear protective hair covering to contain long hair.
ALWAYS USE EYE PROTECTION WHEN WORKING WITH THE TOOL TO
PREVENT EYE INJURY
Ordinary eyeglasses do not provide adequate protection because they have only
impact resistant lenses, they are NOT safety glasses. Also, use a face mask for
additional safety and wear a dust mask if the cutting operation produces dust.
ALWAYS SECURE THE WORKPIECE TO THE FENCE OR THE TABLE
Use clamps or a vise to hold the workpiece in place. It is safer than using your
hand and it frees both hands to operate the tool.
NEVER OVERREACH
Always keep proper footing and balance when working with the tool.
ALWAYS DISCONNECT THE TOOL
before servicing and before changing blades or other accessories.
NEVER RISK UNINTENTIONAL STARTING WHEN PLUGGING IN THE TOOL
Always confirm that the switch is in the OFF position before inserting the power
plug into the receptacle.
NEVER STAND ON THE TOOL
Serious injury could occur if the tool is tipped or if unintentional contact with the
saw blade is made.
NEVER LEAVE THE TOOL RUNNING WHILE UNATTENDED. TURN POWER
OFF
Do not leave tool until it comes to a complete stop. Always turn the power off
when the tool is not in use. Always unplug the power cord when the tool is not in
use.
WARNING