Jensen Hello Kitty KT2024A - Manual (Page 10)

9
AUX IN OPERATION
This CD Player includes an AUX IN JACK so you can enjoy your iPod, MP3 Player or other
audio device.
1. Connect the headphone jack of your external device and the AUX IN jack located on the
back of this CD player. (The connection cable is not included.)
2. Turn on the CD player and it will enter the AUX function mode once the AUX IN jack is
plugged.
3. Start to play your iPod, MP3 player or other audio device.
4. Slowly adjust both the volume controls on your CD player and the external device.
5. Turn off your iPod, MP3 player etc. when you finished listening. Turn the CD player off and
unplug the AUX IN jack.
Remark: Once the AUX IN jack is plugged, the CD player will enter the AUX mode
automatically no matter the FUNCTION Switch is in CD, FM or AM mode. Remember to
disconnect the connection cable from the CD player after use in order to be able to listen to CD
music, FM or AM broadcasts again.
CARE AND MAINTENANCE
1. Children should be supervised when using this appliance.
2. Never wrap the earphone lead around any animal or person. Special care should be taken
with long wires.
3. Clean your unit with a damp (never wet) cloth. Solvent or detergent should never be used.
4. Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
5. Keep your unit away from heating appliances and sources of electrical noise such as
fluorescent lamps or motors.
6. If drop-outs or interruptions occur in the music during CD play, or if
the CD fails to play at all, its bottom surface may require cleaning.
Before playing, wipe the disc from the center outwards with a good
soft cleaning cloth.