JVC GR-DX28 - Manual (Page 17)

EN
17
MasterPage: Advan_Heading0_Right
VID
E
O
RECO
RDI
NG
& PLA
Y
B
ACK
Time Code
During recording, a time code is recorded on the tape.
This code is to confirm the location of the recorded scene
on the tape during playback.
* Frames are not displayed during recording.
If recording starts from a blank portion, the time code
begins counting from “00:00:00” (minute:second:frame).
If recording starts from the end of a previously recorded
scene, the time code continues from the last time code
number.
To perform Random Assemble Editing (
੬ pg. 41 – 44),
time code is necessary. If during recording a blank
portion is left partway through the tape, the time code is
interrupted. When recording is resumed, the time code
starts counting up again from “00:00:00”. This means the
camcorder may record the same time codes as those
existing in a previously recorded scene. To prevent this,
perform “Recording From The Middle Of A Tape” (see
below) in the following cases;
● When shooting again after playing back a recorded tape.
● When power shuts off during shooting.
● When a tape is removed and re-inserted during shooting.
● When shooting using a partially recorded tape.
● When shooting on a blank portion located partway through
the tape.
● When shooting again after shooting a scene then opening/
closing the cassette holder cover.
NOTES:
● The time code cannot be reset.
● During fast-forwarding and rewinding, the time code
indication does not move smoothly.
● The time code is displayed only when “TIME CODE” is set
to “ON”. ( ੬ pg. 30)
Recording From The Middle Of A Tape
1) Play back a tape or use Blank Search ( ੬ pg. 18) to
find the spot at which you want to start recording, then
engage the Still Playback mode. (
੬ pg. 17)
2) Set the Power Switch to “A” or “M” while pressing
down the Lock Button located on the switch, then start
recording.
12 : 34 : 24
Minutes
Seconds
Frames*
(25 frames = 1 second)
Display
VIDEO PLAYBACK
1
Load a cassette. ( ੬ pg. 14)
2
Set the VIDEO/MEMORY Switch to “VIDEO”.
(GR-DX97/77/67only)
3
Set the Power Switch to “PLAY” while pressing down
the Lock Button located on the switch.
4
To start playback, press 4/9.
5
To stop playback, press 8.
● During Stop mode, press 3 to rewind, or 5 to fast-
forward the tape.
To control the speaker volume
Press VOL. + to turn up the volume, or VOL. – to turn
down the volume.
NOTES:
● The playback picture can be viewed in the LCD monitor,
viewfinder or on a connected TV. ( ੬ pg. 18)
● If Stop mode continues for 5 minutes when power is
supplied from a battery, the camcorder shuts off
automatically. To turn on again, set the Power Switch to
“OFF”, then to “PLAY”.
● When a cable is connected to the AV connector, the sound
is not heard from the speaker.
Still Playback
Pauses during video playback.
1) Press 4/9 during playback.
2) To resume normal playback, press 4/9 again.
● If still playback continues for more than about 3 minutes,
the camcorder’s Stop mode is automatically engaged.
Normal Playback
Speaker
4/9
Lock Button
3
VIDEO/MEMORY
(GR-DX97/77/
67only)
Power Switch
8
MENU
5
VOL. +/-
GR-DX97PAL.book Page 17 Tuesday, January 6, 2004 12:44 PM