JVC GR-DX28 - Manual (Page 43)

EDITING
EN
43
MasterPage: Advan_Right
ADV
A
N
C
ED
F
E
A
T
UR
ES
Select Scenes
6
Press PLAY (U) and then press R.A.EDIT ON/OFF on
the remote control.
● The Random Assemble Editing
Menu appears.
7
If using a Wipe/Fader at the
beginning of the scene, press
FADE/WIPE on the remote
control.
● Cycle through the effects by
pressing repeatedly, and stop
when the one you want is
displayed.
8
At the beginning of the scene, press EDIT IN/OUT on
the remote control. The Edit-In position appears in the
Random Assemble Editing Menu.
9
At the end of the scene, press EDIT IN/OUT. The Edit-
Out position appears in the Random Assemble Editing
Menu.
10
If using a Wipe/Fader at the end of the scene, press
FADE/WIPE.
● Cycle through the effects by pressing repeatedly, and stop
when the one you want is displayed.
● If you select a Wipe/Fader effect for an Edit-Out point, the
effect is automatically applied to the following Edit-In point.
● When you use Wipe/Fader effects, that time is included in
the total time.
11
If using Playback Special Effects, press EFFECT.
( ੬ pg. 20)
12
Repeat steps 8 through 11 to register additional
scenes.
● To change previously registered points, press CANCEL on
the remote control. The registered points disappear, one at
a time, from the most recently registered point.
● If you are not using Wipe/Fader or Program AE with special
effects, repeat steps 8 and 9 only.
NOTES:
● When choosing a scene, set Edit-In and Edit-Out points so
that there is a relatively large difference between them.
● If the search time for an in-point exceeds 5 minutes, the
recording deck’s Record-Standby mode will be cancelled
and editing will not take place.
● If there are blank portions before or after the Edit-In and
Edit-Out points, a blue screen may be included in the edited
version.
● Turning off the camcorder’s power erases all registered
Edit-In and Edit-Out points.
● If you select Sepia or Monotone mode from Program AE
with special effects, you cannot use the Black & White
Fader. In this case the Black & White indicator begins
blinking. Once the next Edit-In point is registered, the effect
is turned off. To combine these effects, use Sepia or
Monotone during recording, then use Black & White Fader
during Random Assemble Editing.
● It is not possible to use Wipe/Fader effects and Program AE
with special effects during Random Assemble Editing using
a DV cable.
PLAY
CANCEL
R.A.EDIT
ON/OFF
FADE/WIPE
EFFECT
EDIT IN/OUT
VCR REC STBY
PAUSE
RM-V717U (optional)
1
2
3
4
5
6
7
8
– – : – – ~
~
~
~
~
~
~
~
– – : – –
0 : 00 0
– –
TOTAL
CODE T I ME
N I OUT MODE
Selected parameter
GR-DX97PAL.book Page 43 Tuesday, January 6, 2004 12:44 PM