JVC GR-DVL160 - Manual (Page 10)

10
EN GETTING STARTED
(cont.)
Grip Adjustment
1
Separate the Velcro strip.
2
Pass your right hand through the loop and grasp
the grip.
3
Adjust your thumb and fingers through the grip, to
easily operate the Recording Start/Stop button and
Power Switch and Power Zoom Lever. Be sure to
fasten the Velcro strip to your preference.
Viewfinder Adjustment
1
Set the Power Switch to “ AUTO ” or “ MANUAL ”
while pressing down the Lock Button located on the
switch.
2
Turn the Dioptre Adjustment Control until the
indications in the viewfinder are clearly focused.
Shoulder Strap Attachment
1
Make sure the battery pack is removed. Following
the illustration, thread the strap through the eyelet 1 ,
then fold it back and thread it through the buckle 2 .
Repeat the procedure to attach the other end of the
strap to the other eyelet
3 located under the Grip
Strap . Confirm the strap is not twisted.
Tripod Mounting
CAUTION
When attaching the camcorder to a tripod, extend its
legs to stabilise the camcorder. It is not advised to
use small sized tripods. This may cause damage to
the unit by falling over.
1
To attach the camcorder to a tripod, align the
direction stud and screw to the mounting socket and
stud hole on the camcorder. Then tighten the screw
clockwise. Some tripods are not equipped with studs.
PAUSE
2
1
3
Dioptre
Adjustment Control
Power Switch
Recording
Start/Stop button
Power
Zoom Lever