Jackson 24 LT - Manual (Page 28)

1/2” SOLENOID VALVE & 1/2” NPT VACUUM BREAKER REPAIR PARTS KITS
25
Screw
Data Plate
Coil & Housing
Valve Bonnet
Spring
4810-200-04-18
Plunger
4810-200-04-18
O-Ring
4810-200-03-18
Diaphragm
Retainer
Diaphragm
4810-200-03-18
Screen
Retainer
Mesh Screen
Valve Body
Complete 110 Volt Solenoid Valve Assembly
4810-100-12-18
Coil & Housing only
4810-200-01-18
Complete Vacuum Breaker Assembly
4820-300-07-00
Components of Repair Kit
4820-001-60-56
Cap Screw
Data Plate
Cap
O-Ring
Plunger
Body
Cap Retainer
Possible Problems:
1. Pilot port extension #1 clogged. Clean hole.
2. Hole #2 Clogged. Pass heated straight pin through hole.
1
2
TO TAKE THE SOLENOID VALVE APART
DISASSEMBLY - These valves may be taken apart by unscrewing
the bonnet and the enclosing tube assembly from the valve body
assembly. After unscrewing, carefully lift off the bonnet and enclos-
ing tube assembly. Don’t drop the plunger. The o-ring seal and
diaphragm cartridge can now be lifted out. Be careful not to dam-
age the machined faces while the valve is apart.
TO REASSEMBLE - Place the diaphragm cartridge in the body with
the pilot port extension UP. Hold the plunger with the synthetic seat
against the pilot port. Make sure the o-ring is in place, then lower
the bonnet and enclosing tube assembly over the plunger. Screw
the bonnet assembly snugly down on the body assembly.