John Deere ET-3410-J - Manual (Page 12)

12 Metal Cutting Saw Operator's Manual
SPECIFIC SAFETY RULES:
CONFIRM THAT NO ITEMS SUCH AS AN ELECTRIC CABLE OR
CONDUIT ARE BURIED INSIDE
Be sure the saw will not cut through wire, cable or conduit that are
behind or under the area you are cutting. In such cases, metal parts
could become electrically live and present a serious shock hazard.
KEEP THE RIGHT PARTS IN THE RIGHT POSITION
Do not remove covers and screws which have been factory-mounted.
They perform important respective roles. Keep them in the right
positions.
SHOULD THE PLASTIC HOUSING OR HANDLE OF A POWER
TOOL BE CRACKED OR DEFORMED, DO NOT USE IT
Since cracked or deformed parts may lead to an operator receiving an
electric shock, do not use such a power tool. Immediately have it
repaired.
ALWAYS KEEP THE MOTOR AIR VENT FULLY OPENED
A constantly open motor air vent is necessary to allow air to come in
and out for cooling the motor. Do not allow it to become clogged up,
even if dust is blown through it.
OPERATE POWER TOOLS AT THE RATED VOLTAGE
Operate power tools at voltages specified on the nameplates.
STOP OPERATION IMMEDIATELY IF ANY ABNORMALITY IS
DETECTED
Should a power tool be detected as out of order or should other abnor-
malities be observed during operation, stop using the tool immediately.
NEVER LEAVE TOOL RUNNING UNATTENDED. TURN POWER
OFF.
Don't leave tool until it comes to a complete stop.
CAREFULLY HANDLE POWER TOOLS
Should a power tool be dropped or struck against hard materials
inadvertently, it may be deformed, cracked, or damaged.
DO NOT WIPE PLASTIC PARTS WITH SOLVENT
Solvents such as gasoline, thinner, benzine, carbon tetrachloride, and
alcohol may damage and crack plastic parts. Do not wipe them with
such solvents. Wipe plastic parts with a soft cloth lightly dampened
with soapy water.
KEEP BLADES CLEAN AND SHARP
Sharp blades minimizes stalling and kickback.
ADJUSTMENTS
Before cutting be sure depth and bevel adjustments are tight.
CAUTION