John Lewis JLDW 1225 - Manual (Page 21)

2. Press the delay start button until the
display shows the number of the
selected washing programme.
• The programme number flashes for a
few seconds and then the time of the
washing programme comes on.
3. Close the appliance door. The washing
programme starts automatically.
Warning! Interrupt or cancel a
washing programme in progress only
if it’s absolutely necessary. Hot steam
may escape when the appliance door
is opened. Open the door carefully.
Interrupting a washing
programme in progress
1. Open the appliance door. The washing
programme stops.
2. Close the appliance door. The
programme continues from the point at
which it was interrupted.
Cancelling the washing
programme
If the washing programme has not yet
started, you can change the selection.
When a washing programme is in progress,
you cannot change the selection. You have
to cancel the programme to make a new
selection.
• Press and hold the Reset button until the
display shows two horizontal status bars.
The washing programme has been
cancelled.
Make sure that there is detergent in
the detergent dispenser before you
start a new washing programme.
End of the washing
programme
When the washing programme is
completed, an intermittent acoustic signal
sounds.
1. Open the appliance door.
• The display shows a zero.
• The End indicator is on.
2. Switch off the appliance.
Leave the door ajar and wait a few
minutes before removing the dishes.
In this way they will be cooler and
the drying will be improved.
It is recommended that the appliance
is unplugged and the water tap
turned off when the washing
programme is completed.
Unloading the appliance
• Hot dishes are sensitive to knocks. The
dishes should therefore be allowed to
cool down before removing from the
appliance.
• Empty the lower basket first and then the
upper one; this will avoid water dripping
from the upper basket onto the dishes in
the lower one.
21