John Lewis JLDW 1225 - Manual (Page 9)

• To activate or deactivate the rinse aid
dispenser (only with the Multi tab function
activated).
• To activate or deactivate the acoustic
signals.
Switch on the appliance. The
appliance is in setting mode when:
• The display shows two horizontal status
bars.
Switch on the appliance. The
appliance is not in setting mode when:
• The display shows the time of the washing
programme or of the delay start.
– Cancel the programme or the delay
start to go back to the setting mode.
Refer to 'Select and start a washing
programme'.
Acoustic signals
The acoustic signals indicate:
• The electronic setting of the water
softener.
• The end of the washing programme.
• The intervention of an alarm code related
to a malfunction.
Factory setting: acoustic signals activated.
It is possible to deactivate the audible
signals, using the function buttons on the
control panel.
Deactivating the acoustic signals
1. Switch on the appliance. Make sure that
the appliance is in setting mode.
2. Press and hold function button (B) and
function button (C) simultaneously until
the indicators of function buttons (A),
(B) and (C) start to flash.
3. Release function button (B) and function
button (C).
4. Press function button (C), the indicators
of function buttons (A) and (B) go off
while the indicator of function button
(C) continues to flash. The display
shows the current setting of the acoustic
signals.
Acoustic signals deactivated
Acoustic signals activated
5. Press function button (C) again to
change the setting. The display shows
the new setting.
6. Switch off the appliance to confirm the
operation.
To activate the acoustic signals again, do
steps (1) through (6).
Washing programmes
Programme Degree of soil and
type of load Programme
description Energy save
function
1
45°-70° Auto
1)
Any soil.
Crockery, cutlery, pots
and pans. Prewash
Wash 45 °C or 70 °C
Rinses
Dry YES (impact on
washing
programme)
9