JVC XL-MC222BK - Manual (Page 4)

2
XL-MC222BK
?????
PRECAUTIONS SETTING UP
Installation
• Select the best location
Select a level location to install this component, where it is free
from extremes of temperature (5 to 35°C, or 41 to 95°F) and
humidity, dust, or vibration.
If noise interference is caused in receiving AM broadcast by a
tuner/receiver located nearby, relocate it or this component, or
turn off either one.
• Moving the unit
Before moving the unit, first remove all the discs. Turn the power
off, making sure the standby indicator is on. Then remove the
AC power cord from the AC outlet.
Compact discs
• Use only compact digital audio discs
Only the audio compact discs identified by
the logo shown below can be used with this
component.
Operation
• Keep the disc storage free of obstacles
Do not put anything other than discs in slots of the disc storage.
• Turn the power off if a problem occurs
If an unusual condition arises, turn the power off immediately. If
the condition persists whenever the power is turned on, consult
your JVC dealer.
• Do not pull the AC cord
Do not pull the cable when unplugging the AC cord from the
wall socket or this component — hold and pull the plug body.
• Set the sound volume carefully
Be careful in setting the sound volume on your amplifier/receiver
when playing a CD, which has almost none of background noise
unlike analog records and tapes. Find out the right setting starting
with a low level setting. Setting the level too high and starting a
CD could damage the speakers.
• Protect the component against condensation
Condensation on the component could disrupt the proper
transmission of the disc-reading laser beam, causing noise or
malfunction. If condensation ever ensues due to excessive
humidity or sudden temperature change, leave the component
turned on for a couple of hours to dry up — consult your JVC
dealer if this does not correct the condition.
Connecting the unit
This compact disc changer/player needs to be connected to an
amplifier/receiver for audio reproduction.
CAUTION
Do not connect the AC power cord until all other neces-
sary connections have been made.
1. First connect the OUTPUT ports in the back of this unit with
the CD or AUX input ports of the amplifier/receiver using the
accessory audio cord. Be sure to insert the audio cord jacks
firmly into the proper ports matching the output and input
channels — RIGHT to RIGHT and LEFT to LEFT.
OUTPUT COMPULINK-3
(SYNCHRO)
RIGHT
LEFT
(Red)
(White)
To input audio jack of
the amplifier/receiver
Audio cord
2. If you are connecting the unit to a JVC audio component and
using the CompuLink-3 remote control system, connect the units
with the accessory CompuLink cord. Either one of the
COMPULINK-3 (SYNCHRO) ports in the back of this unit
can be used.
OUTPUT COMPULINK-3
(SYNCHRO)
RIGHT
LEFT
To CompuLink jack
CompuLink cord
When you use the system, you can remote-control this CD unit
from the connected JVC amplifier/receiver. (See Page 11 for
more information.)
NOTE: JVC components equipped with two COMPULINK-3
(SYNCHRO) ports can be connected in series; a com-
ponent with only one port may be connected at the
end of the series.
'
XL-MC222/E B 97.7.15, 5:54 PM 2