JVC XV-NP10S - Manual (Page 14)

12
XV-NP10S/LET0246-003A/English
Ba
si
c ope
rat
io
ns
Basic operations
NOTE
Turning on/off the player
Press DVD STANDBY/ON on the remote
control unit or press on the front panel.
The STANDBY/ON indicator on the front panel, which lights
in red during standby, lights in green.
The left and right sides of the display window are illuminated.
The opening display appears on the TV screen, and the following
messages may appear at the bottom of the opening display.
• NOW READING (The player is reading the disc information.)
• REGION CODE ERROR! (The region code of the DVD VIDEO
disc does not match the player. The disc cannot be played
back.)
• CANNOT READ THIS DISC (The player cannot play back the
disc.)
• OPEN (The disc tray is opening.)
• CLOSE (The disc tray is closing.)
• NO DISC (No disc is loaded.)
NOTES
• Even if you turn off the player, the player is not disconnected
from the AC power source as long as it is connected to the wall
outlet. This state is called standby mode. In this state, the player
consumes a very small amount of power.
• You can change the picture of the opening display. (See page
28.)
Initial setup
When you turn on the player for the first time, the following
message appears on the TV screen.
1 Press ENTER.
The first page of the DVD PLAYER SET UP display appears.
The pull-down menu of the [ON SCREEN LANGUAGE] is
already open.
2 Press 5/∞ to select the desired language.
You can select the on-screen language for the preference
displays, etc. from among ENGLISH, FRENCH, and
GERMAN.
3 Press ENTER.
The second page is shown, in which the pull-down menu of
the [MONITOR TYPE] is already open.
4 Press 5/∞ to select the desired monitor type.
For a normal (conventional) TV, select [4:3 LB] or [4:3 PS].
For a wide-screen TV, select [16:9]. (See page 31.)
Make sure that the TV - DVD switch on the
remote control unit is set to “DVD” when
using the
5/∞/2/3 and numeric buttons
for controlling the player.
About invalid operation icon
When you press a button, and if the player does not accept its
operation,
appears on your TV screen. Operations are
occasionally unacceptable even if is not displayed.
Note that some operations may not be accepted. For example,
some discs may not allow rapid advance/reverse or slow-
motion playback.
STANDBY/ON indicator
TV DVD
NOW READING NOW READING
Message area
EXECUTE DVD PLAYER SETUP? - BASIC PICTURE/AUDIO
SETTING
YES - PRESS ENTER NO - PRESS CANCEL
ON SCREEN LANGUAGE options
MONITOR TYPE options
XV-NP10[B].book Page 12 Wednesday, April 28, 2004 10:08 PM