Jonsered CS 2240 - Manual (Page 39)

40 – English
Assemble on the saw
1. Press the carburettor down towards the parti-
tion wall. Make sure that it gets into the correct
position.
2. Fit the filter holder by hooking the choke con-
trol into the choke lever (A).
3. Hook on the rubber mountings. Insert and
tighten the screws.
Repair instructions
Fig 39
Fig 40
Fig 41
Fig 42
4. Insert the return hose (B) into its position in the
filter holder.
5. Press on the fuel diaphragm (D). Fit the suc-
tion hose (C) and return hose (B).
6. Hook in the throttle actuator rod into the carbu-
rettor. Thread the handle holder into the throttle
actuator rod (A). Push the rod forwards so that
it can be inserted into the handle part.
7. Push down the handle holder into the filter
holder (see figure 42).
8. Assemble the air filter and cylinder cover.
9. Mount the handle holder.