Jensen CR560X - Manual (Page 6)

6
®
CR560X
Wiring with a Wiring Adapter
This is the easiest wiring method, because it replaces your existing radio. You will have to buy a wire
harness adapter from your dealer, a car stereo installation shop or electronics store. If you use a wiring
adapter, you can connect all wires to the radio before you even start to take your old radio out.
Connect Wires
Go to Testing on page 8.
Install Wiring Inside the Car
Wiring Color Codes
Function
LF– Speaker
LF+ Speaker
LR– Speaker
LR+ Speaker
RF– Speaker
RF+ Speaker
RR– Speaker
RR+ Speaker
Power Antenna
Ground
Ignition
Battery Color
white/black
white
green/black
green
gray/black
gray
violet/black
violet
dark blue
black
red
yellow
Splice, crimp or solder the wires from the
Jensen connector to the wiring adapter. Match
the wires according to the chart (below) and
the wiring adapter instructions.
1
3
Antenna
Extender
Cable
2
Car
Antenna
Lead
Car Wiring
Harness
1. Connect wiring adapter to the car's
existing wiring harness.
2. Connect antenna extender cable to car
antenna lead.
3. Slide radio part way into half-sleeve. Splices
You can make all
these connections
without even being
in the car.
Wiring Adapter
(attach to car wiring harness)
5588 CR560X_EIN.p65 2/29/00, 10:46 PM 6