Wiring diagram–advanced installation, Cr560x, Fuses – Jensen CR560X User Manual
Page 7
7
®
CR560X
Wiring Diagram–Advanced Installation
If you are installing new speakers or amplifiers or replacing an aftermarket installation, use this diagram.
Go to Testing on page 8.
Fuses
When replacing a fuse, make sure new fuse
is correct type and amperage. Using an
incorrect fuse could damage radio. The
CR560X uses two fuses with in-line
fuse holders as part of rear wiring harness:
• 5 amp fast blow AGC (yellow wire).
• .5 amp fast blow AGC (red wire).
Accessory
Connect to existing radio wire or
radio fuse.
The radio will not work if this wire
is not connected.
Ground
Connect to ground terminal or clean,
unpainted metal part of chassis.
Power Antenna
Connect to power antenna or ampli-
fier. If not used, tape bare end of
wire.
Memory
Connect to battery or 12 volt power
source that is always live.
The radio will not store time or
station presets if this wire is not
connected.
AMP
Red
White
Amplifier wiring
(See amplifier instructions)
RCA-to-RCA cables
(not supplied)
Back of Radio
Antenna
Jack
LF
LR
RF
RR
LF—
white/black
white
LF+
RF—
gray/black
gray
RF+
LR—
green/black
green
LR+
RR—
violet/black
violet
RR+
+
–
Black
Yellow
Red
AMP
In-line
Fuse
(5 amp)
In-line
Fuse
(.5 amp)
Turn on for amps
Dark Blue
Filter
Box
5588 CR560X_EIN.p65
2/29/00, 10:46 PM
7