Jensen JX1000 - Manual (Page 4)

JX1200
Enclosure Data
Données de Clôture
Datos del Cerco
• Multi-purpose polycone 12"
Subwoofer. Designed for
sealed enclosures
• 600 Watts Peak power
handling, 200 Watts RMS
• 40 oz. magnet
• Efficiency of 90dB SPL
(1W @ 1M), Fs=32.9Hz
• Useable frequency response
24Hz-1kHz
• Subwoofers universels de
12 po. á cúnes en
polypropy-léne pour
enceintes closes
• Puissance de son maximale
en críte 600 Watts, 200
Watts RMS
• Aimant de 40 onces
• Efficacité de 90dB SPL
(1W @ 1M), Fs=32.9Hz
• Réponse de fréquence
utilisable 24Hz-1kHz
• Subwoofers de uso múltiple
de 12î con conos de
polipropileno para cajas
selladas
• Capacidad máxima de
manejo de potencia de 600
Vatios, 200 Vatios RMS
• Magneto de 40 oz.
• Eficiencia de 90dB SPL
(1W a 1M), Fs=32.9Hz
• Respuesta de frecuencia
utilizable 24Hz-1kHz
JX1200: Thiele Small Parameters
Nom. Dia.
12 in (305 mm)
( Fs )/( Fo ) Hz 32.9 Hz
( Vas ) 2.6 ft 3 (73.2 liters)
( Qts )=(Qms x Qes)/(Qms + Qes) 0.40
( Qms ) 8.79
( Qes ) 0.42
( Xmax ) 0.158 in (4.00 mm)
( Pe ) RMS ( Max.) 200W (600 Max.)
( Re ) DC (R) 3.6 Ohm
( Sd ) 70.1 in 2 (452cm 2 )
( Cms ) 0.252 x 10 -3 M/N
( Mms ) 3.27 oz (92.8g)
( Bl ) 12.5 Tm
(SPL ) 90 dB, 1W/1M
VC dia. 2" (51mm)
5 5/8"
(143mm)
5 1/8"
(130mm)
10 15/16"
(277mm)
12 1/4"
(311mm)
JX Series
Jensen recommends that you have your
subwoofers professionally installed. If choosing
to do your own installation, please note the
following:
• Make sure all moving parts and factory
electrical wires are cleared.
• Leave slack in the wire to prevent pulling or
stretching.
• Tie down wires to prevent them from getting
caught or shorted.
• Do not mount subwoofers where they might be
subjected to moisture.
• Correct subwoofer polarity must be used. The
polarity positive side is marked by a (+) sign or
red dot. Subwoofers out-of-phase will have
little bass output.
• Speaker frames will be twisted by installation
on uneven surfaces. This occurs when the
surface is carpeted/padded and screws are
over-tightened.
• If using more than one subwoofers, be sure that
the combined impedance values cannot damage
the amplifier.
• Speaker wire should be isolated from the
vehicleís electrical system to avoid noise being
picked up by the amplifiers. We recommend
Road Gear or Sound Quest brands of wire.
• Speaker wire should be large enough to carry
the full power of the amplifier. 14 gauge or
larger sizes are adequate.
• Be sure to give your ears a break if you listen
loud. Listening loud for extended periods can
damage your hearing!
Notes
TOLL-FREE INSTALLATION ASSISTANCE
The installation and wiring connections for this unit are so simple, we doubt you'll need our help, but, if you
do, we're here to help you. Just call our toll-free telephone assistance line at 1-800-323-4815 during the days
and hours shown (U.S.A. and Canada only)
Hours: 8:30AM - 7:00PM EST Monday - Friday
9:00AM - 5:00PM EST Saturday
.
3 8