JVC TK-C215VP4 - Manual (Page 15)

11
Camera (Interior)
L Rotation Knob
Rotate the lens unit to adjust the inclination of
the image. (
A Pg. 22)
M Rotation Center Mark ( A Pg. 22)
N Fall Prevention Wire
Use this to connect the base G to the dome
cover D.
O Camera Unit Fastening Screw ן 2
Use this to fasten the camera unit Q to the base
G.
To remove (
A Pg. 17)
P [MONITOR]Monitor Terminal (Pin Jack)
( A Pg. 22)
Q Camera
R Connector for Power Supply of Heater
This is a power connector for use when the
heater (sold separately: KA-ZH215) is mounted.
S Space for Heater
T Camera Unit Fastening Lug ן 2
This lug is used for fastening the camera unit to
the base. When removing the base, press
toward the direction indicated by the arrow to
release. (
A Pg. 17)
U Tilt Fastening Screw
Upon adjusting the angle of view, tighten the
screw to ensure that camera’s angle of view
does not go out of alignment when it is used at a
location with strong vibration. (
A Pg. 22)
V Shooting Direction Mark
Install the camera by aligning the shooting
direction with the arrow mark.
W Lug Plate
This plate is used for fastening the silica gel.
(
A Pg. 21)
X Space for Silica Gel
( A Pg. 21)
P
Q
R
L
M
T
U
V
W
O
X
N
S
Lens
(
A next page)
TK-C215VP4_JP.book Page 11 Wednesday, September 20, 2006 5:48 PM