JVC TK-C215VP4 - Manual (Page 2)

Precautions regarding fall prevention
Ⅵ Mounting screws for the base
Be sure to use M4 screw.
Ⅵ Mounting the fall prevention wire
Note:
● Pay attention to the length, strength, routing
and material (insulation properties) of the fall
prevention wire used.
● The internal diameter of the rounded portion
on the camera unit to which the fall
prevention wire is to be mounted shall be at
least
R 4.1 mm and not larger than R 6.5 mm,
and its external diameter shall not be larger
than
R12 mm.
● When mounting the fall prevention wire to the
base, be sure to use the M4 screws mounted
on the base.
Ⅵ Handling camera
Note:
● When mounting the base to the ceiling, or
when connecting the cable of the camera
unit, pay enough attention to the fall of each
part.
Safety Precautions
warning
Mounting to a firm place.
When mounting this unit to the ceiling or wall,
mount it to a secure location where it can
support the mass of this unit. When mounting
to an insecure location, make sure to carry out
reinforcement of the ceiling or wall before
installation.
The camera unit may fall if the mounting screw
or piping is not properly tightened. Ensure that
the screws and nuts are properly tightened.
Mounting the fall prevention wire
Connect the fall prevention wire to prevent this
unit from falling accidentally. The camera unit
may fall if this wire is not connected.
8 mm
2 mm
Fall Prevention
Wire
Base
R4 mm screw
M4 screw
(Attached to the base)
TK-C215VP4_JP.book Page 2 Wednesday, September 20, 2006 6:02 PM