Jwin JX-R86 - Manual (Page 10)

When the alarm function is activated, the recorder will ring for 80 seconds. To end
the alarm sound, press any key.
17. HOW TO SET THE TIME-RECORDING FUNCTION
a. Press and hold the PLAY/OK key for about 2 seconds to enter the setup mode.
b. Use the VOL + or VOL – key to locate the “SEL t-r” menu.
c. Press the PLAY/OK key to enter the “SEL t-r” setup page. You will see the
blinking position and steady number positions on the LCD display. The positions
are in order of Hour-Minute respectively.
d. Use the VOL + or VOL – key to change the hour.
e. Press the PLAY/OK key to confirm the chosen hour. After pressing the key, the
next position for minute will be flickering automatically.
f. Use the VOL + or VOL – key to change the minute.
g. Press the PLAY/OK key to confirm the chosen minute. After pressing the key,
you will see the blinking 3-digit number and this is used to set the length of the
time recording.
h. Use the VOL + or VOL – key to change the minute for the length of the time
recording.
i. Press the PLAY/OK key to confirm the chosen minute. After pressing the key, it
will go to the “ON/OFF” setup page automatically.
j. Use the VOL + or VOL – key to select the “ON” or “OFF” option. Choose the
“ON” option if you want to turn on the time-recording function. Choose the “OFF”
option if you want to turn off the time-recording function.
k. Press the PLAY/OK key to confirm your choice. The LCD display will show the
“SEL t-r” setup menu.
l. Press the REC/STOP key to exit the setup mode.
18. HOW TO USE REPEAT FUNCTION
a. Press the REP key while replaying a recorded message. It will repeat the interval
from the beginning of the recorded message to the point at which you press the
REP key.
b. Press the REP key to end repeating and to continue to play the rest of the
recorded message.