Jwin JX-R86 - Manual (Page 4)

Note:
Old batteries or weakened batteries may cause quality failure in recording.
4. HOW TO USE RECORDING FUNCTION
a. Press and hold the REC/STOP key for about 2 seconds to enter the recording
mode. You will see the record indication on the LCD display.
b. Press the PLAY/OK key to pause recording while in the recording process.
c. Press the PLAY/OK key again if wish to continue recording while in the pause
mode.
d. Press the REC/STOP key to stop recording.
Note:
The total number of the recorded voice message indicator will increase automatically
by 1
5. HOW TO CHANGE THE RECORDING QUALITY (SP, LP)
a. Press and hold the PLAY/OK key for about 2 seconds to enter the setup mode.
b. Use the VOL + or VOL – key to locate the “SEL COdEC” menu.
c. Press the PLAY/OK key to enter the “SEL COdEC” setup page.
d. Use the VOL + or VOL – key to switch from “SP” to “LP” or from “LP” to “SP”.
e. Press the PLAY/OK key to confirm your choice on the quality selection.
f. Press the REC/STOP key to exit the setup mode completely.
Note:
The SP is used for the high record quality, and the LP is used for the lower record
quality with longer recording time option.
6. HOW TO CHANGE THE RECORDING SENSITIVITY
a. Press and hold the PLAY/OK key for about 2 seconds to enter the setup mode.
b. Use the VOL + or VOL – key to locate the “rEC SENSE” menu.