JVC GR-DVL365 - Manual (Page 86)

86
EN
Indications Function
Appears if Insert Editing is attempted on a blank portion of a tape.
(
੬
pg. 64)
● Appears if Insert Editing is attempted on a tape recorded in the LP mode.
(
੬
pg. 64)
● Appears if INSERT (w) on the remote control is pressed when the erase
protection tab is set to “SAVE”. (
੬
pg. 64)
Appears when the memory card’s memory is full and shooting is not
possible.
● Appears if dubbing of copyguarded signals is attempted while this
camcorder is being used as a recorder.
● Appears in the following cases when dubbing from a tape to a memory
card:
– when no memory card is loaded.
– when the memory card's memory is full.
– when the memory card is not formatted.
(
੬
pg. 32, 33)
Appears if there is no memory card loaded when you attempt to record on a
memory card or access data on a memory card.
Appears when there is a problem with a memory card and its memory is
corrupt, or it has not been initialised. Initialise the memory card. (
੬
pg. 36)
Appears if there are no image files stored on the memory card when you
attempt memory card playback.
Appears if there are no E-Mail Clip files stored on the memory card when you
attempt memory card playback.
(
੬
pg. 33)
Appears when the camcorder does not recognize the loaded memory card.
Remove the memory card once and insert it again. Repeat these procedures
until no indication appears. If the indication still appears, the memory card is
corrupted.
Appears if a file in another format is selected.
● Appears when you attempt to record on a copy-protected SD Memory Card.
● Appears when you attempt Memory Card menu operation with a copy-
protected SD Memory Card loaded.
The error indications (E01, E02 or E06) show what type of malfunction has
occured. When an error indication appears, the camcorder turns off automati-
cally. Remove the power supply (battery, etc.) and wait a few minutes for the
indication to clear. When it does, you can resume using the camcorder. If the
indication remains, consult your nearest JVC dealer.
The error indications (E03 or E04) show what type of malfunction has
occured. When an error indication appears, the camcorder turns off
automatically. Eject the cassette once and re-insert it, then check if the
indication clears. When it does, you can resume using the camcorder. If the
indication remains, consult your nearest JVC dealer.
PLEASE
FORMAT
MEMORY CARD!
or
PLEASE INSERT CARD
COPYING FAILED
CARD ERROR!
CHECK CARD’S WRITE
PROTECTION SWITCH
MEMORY IS FULL
INSERT ERROR!
<CANNOT EDIT
ON A LP RECORDED TAPE>
<CHECK TAPE’S ERASE
PROTECTION TAB>
NO IMAGES STORED
UNSUPPORTED FILES
INDEX
Indications (cont.)
INSERT ERROR!
E01, E02 or E06
UNIT IN SAFEGUARD
MODE REMOVE AND
REATTACH BATTERY
E03 or E04
UNIT IN SAFEGUARD
MODE EJECT AND
REINSERT TAPE
NO E-MAIL CLIP STORED