System menu – JVC GR-DV4000 User Manual
Page 37
EN
37
Master Page: Right
Snapshot flash
B-IN FLASH
(Factory-preset: AUTO)
OFF: Will not fire.
AUTO: Fires automatically if it is dark ( appears).
AUTO C: Fires automatically if it is dark (
appears) and reduces the Red-Eye effect in the
subject’s eyes.
ON: Always fires.
Flash brightness adjustment
FLASH ADJ.
(Factory-preset: ±0)
For details, refer to “Flash Brightness Adjustment”
(
SYSTEM
Beep, melody and shutter sound
BEEP
(Factory-preset: MELODY)
OFF: Even though not heard while shooting,
shutter sound is recorded on the tape.
BEEP: The beep sounds when the power is turned
on or off, and at the beginning and end of
recording. It also activates the shutter sound
effect. (
MELODY: Instead of a beep, a melody sounds
when any operation is performed. It also activates
the shutter sound effect. (
Tally lamp setting
TALLY
(Factory-preset: ON)
OFF: The tally lamp remains off at all times.
ON: The tally lamp comes on to signal the start of
recording.
Remote control setting
For details, refer to “USING THE REMOTE
CONTROL UNIT” (
REMOTE (Factory-preset: ON)
OFF: Disables the remote control operations.
ON: Enables the remote control operations.
Automatic demonstration mode
Demonstrates certain functions such as Program AE
with special effects, etc., and can be used to confirm
how these functions operate. (
DEMO MODE
(Factory-preset: ON)
OFF: Automatic demonstration will not take
place.
ON: Demonstrates certain functions such as
Program AE with special effects, etc., and can be
used to confirm how these functions operate.
Demonstration starts in the following cases:
•When the Menu Screen is closed after “DEMO
MODE” is turned “ON”.
•With “DEMO MODE” set to “ON”, if there is no
operation for about 3 minutes after the Power
Switch is set to “A” or “M”.
Performing any operation during the
demonstration stops the demonstration
temporarily. If no operation is performed for more
than 3 minutes after that, the demonstration will
resume.
NOTES:
● If a cassette is in the camcorder, the demonstration
cannot be turned on.
● “DEMO MODE” remains “ON” even if the
camcorder power is turned off.
● If “DEMO MODE” remains “ON”, some functions
will not be available. After viewing demo, set to
“OFF”.
System Menu
GR-DV4000PAL.book Page 37 Friday, February 14, 2003 10:30 PM