JVC HR-5910U - Manual (Page 19)

EN
19
Turn on the VCR and the TV, and select the VCR
channel 3 or 4 (or AV mode) on the TV.
INITIAL SET
CLOCK SET
LANGUAGE
ENGLISH
GUIDE CHANNEL SET
CABLE BOX SET
=DBS RECEIVER SET
SELECT WITH ( 5,∞) AND (OK)
PRESS (MENU) TO END
DBS RECEIVER SET
OFF
PRESS ( 5,∞), THEN (OK)
PRESS (MENU) TO END
2
Access Main Menu screen on VCR
Press MENU.
3
Access Initial Set screen
Press SHUTTLE PLUS %fi to move the highlight
bar (arrow) to “INITIAL SET”, then press OK or
SHUTTLE PLUS
#.
4
Access DBS Receiver Set screen
Press SHUTTLE PLUS
%fi to move the
highlight bar (arrow) to
“DBS RECEIVER SET”,
then press OK or
SHUTTLE PLUS
#.
5
Select DBS receiver output channel
Your selection depends
on how your DBS
receiver is connected to
your VCR.
● If your DBS receiver
is connected to your
VCR’s ANTENNA IN
terminal on the rear
Press SHUTTLE PLUS
%fi on the Remote until
the channel number representing the DBS
receiver’s output (CH3 or CH4) appears on the
screen.
● If your DBS receiver is connected to your VCR’s
AUDIO/VIDEO IN connectors on the front panel
Press SHUTTLE PLUS
%fi on the Remote until
“ON F-1 (FRONT)” appears on the screen.
● If your DBS receiver is connected to your VCR’s
AUDIO/VIDEO IN connectors on the rear panel
Press SHUTTLE PLUS
%fi on the Remote until
“ON L-1 (REAR)” appears on the screen.
● If you do not use a DBS receiver
Press SHUTTLE PLUS
%fi on the Remote until
“OFF” appears on the screen.
CONTINUED ON NEXT PAGE \
1 2 3
4 5 6
7 8 9
0
2
4
1
3
2
3 4
3 – 5
Setting DBS receiver output
channel & brand
After installation, set the DBS receiver’s output channel
and its brand correctly; otherwise, the Controller cannot
work correctly.
1
Turn on DBS receiver
Select a channel other than channel 55, 100 or
205 on your DBS receiver.