JVC TK-WD310 - Manual (Page 5)

10
Names and Operations of Parts
[Rear Panel]
SEE INST-
RUCTION
MANUAL
DC12V
AC24V 1 2
CLASS 2 ONLY (U TYPE)
ISOLATED POWER ONLY
(E TYPE)
POWER VIDEO OUT
INT LL
SET SELECTOR
8
[DC 12V, AC 24V] Power input terminals
To input DC 12V or AC 24V power.
9 [VIDEO OUT] Video signal output connector
This BNC connector outputs a composite video signal. Con-
nect this to the video input connector of a video monitor,
switcher, etc.
0
[POWER] Power indicator lamp
This lamp lights when power is supplied to the camera.
INTRODUCTION
A
B
8
9
C
0
11
A [SET] button
During normal screen display, pressing and holding this button
for more than 2 seconds will display the MENU screen.
(
੬ Page 24)
During MENU screen display, this button is pressed to display
or enable the selected menu item. The input digit will change
when entering the camera title.
When selecting EXIT in the TOP MENU screen, pressing this
button will return to the normal screen.
B
[SELECTOR] button
Used when performing menu settings.
This button is a multidirectional switch.
Ⅵ Pressing in a vertical direction (6 or 7) will select the menu
item.
Ⅵ Pressing in a horizontal direction (8 or t) will change the
set value of the item. When entering the camera title, the
input character will change.
C
[INT/ LL] Selector Switch for Synchronizing System
This switch can set a synchronizing system of the camera.
INT:
This is set for internal synchronization (INT) .
LL (Line Lock):
The camera’s vertical synchronization is locked to the AC 24V
power line frequency.
When switching between multiple cameras using a switcher,
selecting this mode and adjusting the vertical phase can re-
duce the monitor sync disturbances occurring when the cam-
era image is switched. (This cannot be used in regions where
the power frequency is 50 Hz (60 Hz) . ( ): TK-WD310E)
(INT: At time of factory shipment)
12
Names and Operations of Parts
[Side Panel]
COLOR VIDEO CAMERA
IRIS
DC VIDEO
D
[VIDEO/DC] Iris Selector Switch
This should be set according to the type of lens if an automatic
iris control lens is used.
VIDEO : In case of lens with EE amp built-in.
( ੬ Page 20)
DC : In case of lens without EE amp built-in.
( ੬ Page 14)
(DC : At time of factory shipment)
E
[IRIS] Iris Terminal
This is connected to an automatic iris control lens.
(
੬ Page 15)
INTRODUCTION
D E
13
Basic System
Ⅵ System with up to 8 cameras
REC
PLAY FF REW REVERSE PAUSE/
STILL
REC
CHECK STOP/EJECT
COUNT/
CLOCK TIME
MODE TIMER
REC AL/PL
RESET MENU
VIDEO CASSETTE RECORDER
SHIFT/TRACKING SET/V.LOCK RESET
/CANCEL
OPERATE SR-L910
OPE. LOCK
• • • • • •
COLOR VIDEO CAMERA ALC LEVEL
Av Pk
L H
COLOR VIDEO CAMERA ALC LEVEL
Av Pk
L H
COLOR VIDEO CAMERA ALC LEVEL Av Pk L H
Switcher
Video signal cable
Power
cable
AC24V or
DC12V
AC24V or
DC12V
AC24V or
DC12V
Camera 1
Camera 2
Camera 8
Monitor
Monitor
DVR, etc.
CONNECTION/INSTALLATION