Jonsered GR 2126D - Manual (Page 17)

English –
17
Assembling the handlebars
ASSEMBLY
• Remove the screw at the
rear of the throttle
handle.
• Slide on the throttle
handle on the right-hand
side of the handlebars,
(see the diagram).
• Align the hole in the
throttle handle for the
fixing screw with the
hole on the handlebars.
• Refit the screw in the
rear of the throttle
handle.
• Fit the screw through the
throttle handle and the
handlebars and tighten.
• Fit the bracket
components as shown in
the diagram.
• The handle mounting
must be fitted between
the arrows on the shaft.
• Loosely tighten the four
screws.
• Put on the harness and
hang the machine in the
suspension hook. Now
finely adjust so that the
machine gives a
comfortable working
position when it’s
attached to the harness.
Tighten the screws.
Assembly of the blade and trimmer
head
It is extremely important that
the disc drive’s/support
flange’s guide engages
correctly in the cutting
equipment’s centre hole when
assembling the cutting
equipment. Cutting
equipment assembled
incorrectly can result in
serious and/or fatal personal
injury.
• Hook the guard (A) onto
the bracket on the shaft
and secure with 1 bolt.
NOTE! Use the
recommended blade guard.
“See Technical data“.
• Fit the drive disc (B) on
the output axle.
• Turn the blade axle until
one of the holes in the
drive disc aligns with the
hole in the gear housing.
• Insert the locking pin (C)
in the hole so that the axle
is locked.
• Place the blade (D),
support cup (E) and
support flange (F) on the
output axle.
• Fit the nut (G). The
tightening torque of the
nut is 35-50 Nm (3,5 - 5
kpm). Use the socket
Assembling the blade guard and
grass blade
IMPORTANT INFORMATION
The machine must be equipped with the correct
handlebars, blade guard and harness if either a
clearing blade or grass blade are to be used.
WARNING!
Do not attach any blade to the unit
without proper installation of all required
parts. Failure to use the proper parts can
cause the blade to fly off and seriously
injure the operator and/or bystanders.
Under no circumstances may the cutting
equipment be used without an approved
guard fitted. See the chapter
“Technical
data”. If the wrong guard or a defective
guard is fitted this can cause serious
personal injury.
!
spanner in the tool kit. Hold the handle of the spanner as
close to the blade guard as possible. The nut is tightened
when the spanner is turned against the direction of rotation
(left-hand thread).
G
F
D
B
C
A
E