JVC HR-XV1EK - Manual (Page 16)

16
This VCR has one built-in tuner to
receive broadcasts. Before you
record a TV broadcast, you must set and
preset all channels. This VCR can preset
up to 80 channels.
Tuning the TV Stations Manually
• Turn on the TV, and select the VCR channel on TV.
• Make sure TV/VCR/DVD switch has been slided to VCR/
DVD. Then press VCR to select the VCR mode. (The VCR
indicator will light)
Preparation
CH 01
CH 02
CH 03
CH 04
CH 05
CH 06
BBC 1
BBC 2
ITV
CH4
CH5
SATELLITE
3
Press (falling frequency) or (rising frequency)
once to start the search. It stops at each broadcast
Press
▲
or
▼
repeatedly
until 2 is displayed. (Or
enter 0 2 with the 1 to 0
numbered keys). Then
press OK.
4
5
6
Press SET UP MENU repeatedly until the TV picture ap-
pears on the screen.
Repeat the steps 3 and 4 to preset other TV stations.
automatically (" "
changes to " "). Press
or repeatedly until
BBC 2 appears. Only in
case of receiving a weak
broadcast (drifting
picture), does search fail
to stop. If you want to
stop, press
or .
Press OK to preset. The
search menu screen will
disappear if the next
mode is not activated in
less than 50 seconds.
CH 1
: MENU
SEARCH :
EXIT
CH 1
EXIT : MENU
CH : / 0-9
OK : OK
1
Press SET UP MENU.
Press
▲
or
▼
to select
the CHANNEL SETUP.
Then press OK.
Example: Preset the BBC 2 on programme position 2.
Note:
Occasionally, the auto search might catch
a weak signal and stop. If the TV station
signal is weak, you shouldn't store this
station.
In that case restart the auto search
using
or .
CH 2
EXIT : MENU
SEARCH :
OK : OK
SELECT :
CHANNEL SETUP
ENTER
EXIT : OK
: MENU
VCR SETUP
AUTO REPEAT OFF
SYSTEM SETUP
TIMER REC SET
2
Press
▲
or
▼
to select
the CH TUNING.
Press OK to select CH
TUNING screen.
SELECT :
CH TUNING
ENTER
EXIT : OK
: MENU
GUIDE CH SET
CHANNEL SETUP
2A77501B E(12-17) 5/30/02, 9:21 PM 16