Jet Tools Drum Sander - Manual (Page 9)

9
Assembling the Open Stand (Optional Accessory)
(Refer to Figure 3. If further clarification is needed, consult the parts breakdown on page 35.)
Tools required for Stand assembly: Ratchet wrench with 1/2” socket
1. Assemble legs (H) to outside of Short Rails (L) using carriage bolts (N) and flanged lock nuts (O).
Finger tighten only.
2. Assemble Long Rail (K) on inside of legs and on top of Short Rails (L). Finger tighten only. NOTE:
Flange of Long Rail (K) overlaps flange of Short Rail (L). See Detail 1 below.
3. Turn stand upside down. Install shelf (J) into legs (H) using carriage bolts and lock nuts.
4. Fully tighten all flanged lock nuts in shelf and legs.
5. If you are using the provided leveling foot (M), place it in bottom hole of leg by placing a hex nut (P)
and flat washer (R) above and below the leg flange. If you are mounting the optional casters, see
“Casters” below.
6. Turn stand right-side up, and level it using the leveling feet. Tighten the leveling feet hex nuts against
the leg flange.
Casters (Optional Accessory)
1. If you are installing the optional casters, press down on the tab to lock the caster, then remove the
hex nut and washer with a 19mm wrench. Install the caster through the hole in the stand leg and
secure it with the washer and hex nut. See Detail 2 below.
2. Press down with your foot on the large tab to lock a caster; press down on the small tab to unlock it.
Figure 3