John Lewis JLBIDW 901 - Manual (Page 10)

Multi-tab function
This appliance is equipped with the “Multi-tab” function, that
allows the use of the combi detergent tablets with a combined
cleaning, rinsing and salt function (“3 in 1”,“4 in 1”,“5 in 1” etc...).
Before using the “Multi-tab” function, check that
the water hardness level in your area complies
with the detergent manufacturers
recommendations.
This function can be selected with all washing programmes.
With the selection of this function the inflow of rinse aid and salt
from each respective supply container is automatically
deactivated and also the indicator lights for salt and rinse aid are
deactivated.
Select the “Multi-tab” function before the set of a washing
programme.
Once selected this option (indicator light illuminated) it will
remain active also for the following washing programmes.
With the use of the “Multi-tab” function, the cycle durations
may change. In this case, in the digital display, the indication of the
running time of the programme is automatically updated.
NOTE: Once the programme is running, the “Multi-tab”
function can NO longer be changed. If you want to exclude the
“Multi-tab” function you have to cancel the programme setting
(see chapter "Starting a washing programme" - "Cancel a washing
programme in progress") and then deactivate the “Multi-tab”
function. In this case you have to set a washing programme (and
desired options) again.
NOTE: if the drying results are not satisfactory we suggest that
you activate the rinse aid dispenser.
The activation/deactivation of the rinse aid dispenser can only be
possible with the “Multi-tab” function active.
Activation/deactivation of the Multi-tab function
● Press simultaneously the two buttons positioned over the
writing “Multi-tab”, until the “
Multi-tab ” function indicator
light illuminates.This means that the function is active.
● To deactivate the function press the same buttons again until
the “
Multi-tab ” function indicator light turns off.
Activation/deactivation of the rinse aid
dispenser
The dishwasher must be switched off
When the rinse aid dispenser has been activated, the
rinse aid indicator light on the control panel is
automatically activated.
1. Press the On/Off button.The indicator lights of the
programme selection buttons will illuminate (setting mode).
If only one programme button indicator light is on, this means that
a washing programme is set.The programme must be cancelled:
press simultaneously function buttons 2 and 3 for about 2
seconds.All programme indicator lights will illuminate indicating
that the set programme has been cancelled and the machine is
now in setting mode.
2. Press simultaneously function buttons 2 and 3, until the
indicator lights of function buttons 1, 2 and 3 start flashing.
3. Press function button 2, the indicator lights of function
buttons 1 and 3 turn off while the indicator light of function
button 2 goes on flashing, the digital display indicates the
current setting.
4. To change the setting, press function button 2 again, the
digital display indicates the new setting.
5. To memorise the operation, switch off the dishwasher by
pressing the On/Off button.
10
Rinse aid dispenser deactivated
Rinse aid dispenser activated