John Deere ET-3407 - Manual (Page 10)

10 14-Inch Abrasive Chop Saw Operator's Manual
Operation
ASSEMBLY:
1. This cut off saw is shipped with the cutting head
locked in the down position.
2. Remove locking chain to have cutting head in
up position.
3. Raise wheel guard, push in spindle lock. (Fig. 2)
4. Use the wrench provided with the saw, to loosen
the hex bolt which serves to hold the cutting
wheel in place. Then remove the outer flange.
(Fig. 3)
5. Install the cutting wheel on the arbor shaft.
6. Reinstall the outer flange, then tighten hex bolt.
7. Make sure the cutting wheel is secured by
turning it with your hands.
Spindle
Lock
(Fig. 3)
(Fig. 2)