Jackson JFT - Manual (Page 3)

Power Rinse Tank Final Rinse Blower Dryer
Unload
Stainless steel power rinse arms with
stricture free jets mounted above and
below the wares are easily removable
for cleaning.
A 2.0 HP, 1725 RPM motor with a
stainless steel housing and impeller
are included. Power rinse tank is a
sloped design to ensure complete
tank draining and to minimize soil
build-up
Stainless steel rinse arms with jets
mounted above and below the wares
are easily removable for cleaning.
The final rinse water will cascade back
to the power rinse, wash and then the
pre-wash tanks.
A stainless steel tunnel incorporat-
ed into the discharge section of the
machine. The blower dryer keeps the
operating personnel from removing
the wares before it reaches the end of
the unload section. An industrial fan-
type with a squirrel cage driven by
a 0.6 HP direct drive motor dries the
wares as it exits the machine.
*The Blower Dryer is an option
and must be specified at time
of order.
A “start/stop” switch is located at
the unload end of the machine for
the operators convenience.
Unload platform is 14 gauge stain-
less steel.
The drive wheel shaft is supported
by two heavy-duty grease-lubri-
cated ball bearings in pillow blocks.
Power Rinse Tank
Height
Depth Length
73”
(1854 mm) 46”
(1168 mm) 36”
(914.4 mm)
Final Rinse
Height
Depth Length
82”
(2083 mm) 46”
(1168mm) 36”
(914.4 mm)
Blower Dryer
Height
Depth Length
88“
(2235 mm) 38-1/4”
(972 mm) 36
(914.4 mm)
Unload
Height
Depth Length
36”
(914.4 mm) 38-1/4”
(972 mm) 42”
(1067 mm)
Power Rinse Tank
Height
Depth Length
79”
(2007 mm) 48”
(1219 mm 60”
(1524 mm)
Weight: 627 lbs / 284 kg
Final Rinse
Height
Depth Length
88”
(2235 mm) 48”
(1219 mm 60”
(1524 mm)
Weight: 635 lbs / 288 kg
Blower Dryer
Height
Depth Length
93”
(2362 mm) 48”
(1219 mm 60”
(1524 mm)
Weight: 504 lbs / 229 kg
Unload / Load
Shipped with load end