Installing the battery pack – JVC 0997TOV*UN*SN User Manual

Page 9

Advertising
background image

EN

9

NOTES:

● If you connect the camcorder’s DC cord to the adapter during battery charging, power is supplied to the

camcorder and charging stops.

● When using the AC Power Adapter/Charger, be sure to use the supplied power cord only.

● The AC Power Adapter/Charger is for use with the BN-V907U Battery Pack only.

● When charging the Battery Pack for the first time or after a long storage period, the Charger Indicator may

not light. In this case, remove the Battery Pack from the AC Power Adapter/Charger, then try charging
again.

● Since the AC Power Adapter/Charger processes electricity internally, it becomes warm during use. Be sure

to use it only in well-ventilated areas.

● If the battery operation time remains extremely short even after having been fully charged, the battery is

worn out and needs to be replaced. Please purchase a new one.

** Charging Environment

Perform charging where the temperature is between 10° and 30°C. (20°–25°C is the ideal temperature range for
charging.) If the environment is too cold, charging may be incomplete.

Continuous Shooting

Continuous shooting is possible (See table below for recording time) under the following conditions:
• A BN-V907U Battery Pack is in use
• The temperature is approximately 20°C/68°F
However, . . .
• If the temperature is below 10°C/50°F, or
• If zoom or Record-Standby are engaged or LCD monitor is used repeatedly, continuous shooting capability

is reduced significantly. Before extended use, it is recommended that you prepare enough battery packs to
cover 3 times the planned shooting time.

Installing The Battery Pack

The battery pack does not charge while in the camcorder. Before installation, make sure the battery pack has
been charged fully.

1

2

1

2

3

1

OPEN BATTERY COVER

1

Slide the battery cover.

2

Pull open the battery cover in the direction
of the arrow.

2

INSERT BATTERY

Insert the

mark end of the battery first.

3

CLOSE BATTERY COVER

Close the battery cover while pulling it and
slide it in the direction of the arrow.

BATTERY

LCD monitor off/

LCD monitor on/

Viewfinder on

Viewfinder off

BN-V907U

approx. 45 min.

approx. 40 min.

NOTES:

● To remove the battery pack, turn off the

camcorder, open the battery cover and slide the
battery pack out.

● Be careful not to drop the battery pack.

RECORDING TIME

mark

Battery

Battery cover

Advertising